| FORUM

FEDEVEL
Platform forum

USE DISCOUNT CODE
EXPERT30
TO SAVE $30 USD

Forum / Schematic Design & PCB Layout / Help Needed with Creating Schematic and Footprint for RTC Module DS1307 in Altium

Help Needed with Creating Schematic and Footprint for RTC Module DS1307 in Altium

sal7oufa , 07-17-2025, 08:36 AM

I am currently working on a PCB project and would like to include an I2C Real-Time Clock module (DS1307 + 24C32) on my custom PCB. Unfortunately, I could not find the corresponding schematic symbol and footprint for this module in available libraries, such as SnapEDA.

As I am still a beginner with Altium Designer, I would appreciate your guidance or support in designing the schematic symbol and PCB footprint for this module.

Below, I have included the link to the webpage where I purchased the component, in case you need more details regarding its layout and dimensions:

https://2btrading.tn/accueil/454-module-horloge-i2c-module-rtc-temps-reel-ds1307-24c32.html

Thank you in advance for your help and support.

QDrives , 07-17-2025, 12:20 PM

https://www.youtube.com/watch?v=KpgTud1iQ-4&pp=ygUccm9iZXJ0IGZlcmFuZWMgY3JlYXRlIHN5bWJvbA%3D%3D

QDrives , 07-17-2025, 12:20 PM

https://www.youtube.com/watch?v=wxYbIGV9_CY&pp=ygUfcm9iZXJ0IGZlcmFuZWMgY3JlYXRlIGZvb3RwcmludA%3D%3D

QDrives , 07-17-2025, 12:20 PM

https://www.youtube.com/watch?v=6AU94oTnG68&pp=ygUfcm9iZXJ0IGZlcmFuZWMgY3JlYXRlIGZvb3RwcmludA%3D%3D

QDrives , 07-17-2025, 12:21 PM

https://www.youtube.com/watch?v=cMxXea16Hxc&pp=ygUfcm9iZXJ0IGZlcmFuZWMgY3JlYXRlIGZvb3RwcmludA%3D%3D

Robert Feranec , 07-17-2025, 01:46 PM

it is not difficult to learn. @QDrives attached good videos, you can also have a look at thisone: https://youtu.be/KWIzhbQaZZk

sal7oufa , 07-17-2025, 01:48 PM

thank you very much for responding , i will do my best , also , i have watched some of your vds and i'm learning actually , thanks

sal7oufa , 07-21-2025, 08:40 AM

hello again , please help me correct this schematic , i couldn't understand the errors ( error : Details

GND contains Output Pin and Power Pin objects (Pin PS1-3, Pin U1-14, Pin U1-38).) , i did put GND power port , yet it did not work , also there is some warnings .