Announcement

Collapse
No announcement yet.

Android OS on Openrex

Collapse
X
  • Filter
  • Time
  • Show
Clear All
new posts

  • Android OS on Openrex

    Hi I've recently purchased an OpexRex board and I've been having some difficulty with installing Android OS. It was shipped with Linux Terminal.

    This was the guide I was following.

    http://www.imx6rex.com/software/how-...d-on-imx6-rex/

    I've followed the steps but when hooking up the board to a display using HDMI, I receieve "No Signal". I'm not entirely sure what went wrong during the installation. Several things I've noticed is that when I run this script:

    sudo ./fsl-sdcard-partition.sh -f /dev/sdb

    I get an output that looks like the image attached.

    Did I do something wrong? I wasn't sure how to complete the "Initalize Boot Loader" step, as it tells me in a different guide (the one on voipac), where it says to get "uboot". Well I attempted to do so but I was unable to register on NXP to obtain such information (didn't receive an email).

    Is it possible to obtain another explanation of the steps that I must undergo in order to install Android OS?

    Thank You,
    OpenRex Customer




  • #2
    These images are for the iMX6 Rex module (it's a different board). The best is to double check with VOIPAC ( http://www.voipac.com/ ). I know they are planning to port Android on OpenRex, I am just not sure what the current status is.

    Comment

    Working...
    X